Patch Request: Statiqbloom - Possession (Lead)

Thanks Joe. I’m on serum so I only have the two main oscillators, for the third one you listed would it work the same if I used the sub oscillator?

Yes

Try this:

Oscillator

– 1: Pulse wave. Set pulse width to a little less than full Square.

– 2: Sine wave. Mix a bit in just to fatten up the pulse wave sound.

– 3: Pulse wave. Full square, once octave below. This should be quite than Osc 1, but loud enough to get some of that low growl in there.

Unison: 4 voices, a little width, pretty heavy detune.

Filter: Lowpass, 24 dB. Bring Cutoff down about halfway to get a pretty round sound. Then modulate it with…

LFO: Fast saw wave. This will create a repeating-note effect while also creating a quick decaying filter shape. Play around with the LFO Amount and Filter Cutoff until you get the right sound.

Thanks Joe. I'm on serum so I only have the two main oscillators, for the third one you listed would it work the same if I used the sub oscillator?

Try this:

Oscillator

• 1: Pulse wave. Set pulse width to a little less than full Square.
• 2: Sine wave. Mix a bit in just to fatten up the pulse wave sound.
• 3: Pulse wave. Full square, once octave below. This should be quite than Osc 1, but loud enough to get some of that low growl in there.

Unison: 4 voices, a little width, pretty heavy detune.

Filter: Lowpass, 24 dB. Bring Cutoff down about halfway to get a pretty round sound. Then modulate it with...

LFO: Fast saw wave. This will create a repeating-note effect while also creating a quick decaying filter shape. Play around with the LFO Amount and Filter Cutoff until you get the right sound.