Patch Request: Cametek - Under Construxion (Lead)

Patch / Preset Recreated

The lead takes over after the guitar at 0:25 (the link starts there) This may be a challenge cause everything is so loud. Thanks for any help!

Flynn Essex

5 years ago

Activity
Flynn Essex

Thanks Joe!

0    5 years ago    Reply

Comment must be at least 20 characters.
Cancel

Please use markdown for styling

Joe Hanley

Try this:

Oscillators: Two oscillators, both Saw. Set Unison voice count pretty high, with a fairly strong detune so it sounds a little pitchy, and keep the width modest so it's not fully wide. Then pitch the second oscillator down one octave.

Filter: Low Pass 24 dB. Bring the Cutoff down to round of a good chunk of highs, but still leaving it pretty bright. Give it a healthy does of Resonance to make the pointier and kind-of nasal. Add a second filter, High Pass 12 dB, and take off enough Lows to remove the bottom frump and make the sound lighter.

Voices: Mono, with a noticeable Portamento. You should really be able to hear each note bend into the next.

Compression: Squeeze it a bit. Doesn't need to be a ton. Just enough to make the pulsations from the Unison start fight the compressor, making the overall sound kind of aggressive.

Reverb: It's hard to hear because the tracks are so dense, but I think there's some space around the sound. Moderate Decay, just a little wet.

0    5 years ago    Reply

Comment must be at least 20 characters.
Cancel

Please use markdown for styling

Flynn Essex

It's the same patch as the one in this song at 1:17 as well, and it's easier to hear here.

0    5 years ago    Reply

Comment must be at least 20 characters.
Cancel

Please use markdown for styling

2 votes
Categories
Synth Patch / Preset Request